|
Scott Flex Tester
This tester is used for
determining the degree of finish peeling or crazing due to roll flexing. The unit is designed with two sample clamps
that can have the distance between adjusted to a required length. Once the samples are locked in place the
clamps can be compressed together to a required load, thus forcing the samples
to roll 180 degrees under pressure. Once
the samples are in this compressed state the machine can be turned on and the
drive engaged. This will slide one of
the sample clamps in a back and forth motion, causing the crease flex action
required. This slide length is also adjustable,
but set before the test starts. This machine has an adjustable cycle counter with
automatic shut off. Upon completion of
the test, the samples are removed and examined visually for damage.
Specification:
Meets requirements of Toyota TSL5101G (Section 3.29) Meets requirements of Nissan NES M0155 (Section 17)
|
 |
 
|
|
